Your POS HUB must have a hard-wired internet connection. In the event there isn't a hard-wire available from the router, you can install a WiFi bridge to provide the required connection.
Set Up Wi-Fi bringe using WPS function:
1. Plug the Wi-Fi extender into a power outlet close to the root wireless access point and switch it on (1). The extender will automatically initialize. In a few seconds, the Power LED ( ) will light up. Approximately 30 seconds afterwards, the Wi-Fi LED ( ) will begin to flash rapidly and irregularly (2). This indicates initialization is complete. Please do not proceed to step 2 until these conditions are fulfilled.
2. Press and hold the WPS button on the extender for 2 seconds, until the WPS LED starts flashing.
3. Press the WPS button on the root wireless access point within 2 minutes to establish a connection. The amount of time the button should be held down will vary between different routers, some will work with a quick press, while others may require holding the button down for 2 seconds or more.
Note: Some wireless routers may reboot if the WPS button is held down for too long. To prevent accidentally rebooting your router, please refer to your router user manual for detailed instructions regarding WPS operation.
4. The WPS LED will go through a series of flashes over the next 60 to 90 seconds. When a WPS connection has been successfully established, the green WPS LED will stay on, and the Signal Strength LED will light up in orange.
Troubleshooting: If the WPS LED continues to blink in regular two-second intervals 30 seconds after pressing the WPS button on the access point, then the Wi-Fi extender did not detect the WPS signal from the access point. Please return to step 3. If an error occurred, the WPS LED will flash rapidly. Please wait for the WPS LED to deactivate and try again from step 1. 5 minutes after a WPS connection has been established, the WPS LED will automatically deactivate. The WPS connection between the extender and the wireless access point will remain active.
Set Up Wi-Fi bringe using manufacture instructions:
Follow manufacturers instructions (starting on page 5) of this manual for configuration instructions. Note, that your WiFi bridge/extended MUST be in the same network as your iPad POS.
Restart your Edimax extender once configuration is completed.